Manual AIA2-10K2 IS
AIA2-10K2 IS specifications
ASCENDO AIA-10K2 IS: Experience Unmatched Bass Power with Our Revolutionary 1U 19” Bass AmplifierAfter nearly a decade of pioneering the infrasonic subwoofer market, ASCENDO has solidified its position as the undisputed leader in this specialized category. We've consistently pushed the boundaries…
Inputs
Analog Input Impedance
10 kΩ + 10 kΩ (+/- 1%)
Channels
2
Signal-to-Noise Ratio A-Weighted 20 Hz – 20 kHz
105 dB
Nominal sensitivity for maximum output level (balanced) Sensitivity (@ 32 dB)
1.9 V (rms)
Input sensitivity
-95.5 dB – 0 dB (steps 0.5 dB)
Outputs
Output Power (EIAJ Test Standard 1 kHz 1% THD)
230 V @ 4 Ω – 2 x 5000 W 230 V @ 8 Ω – 2 x 2600 W 230 V @ 2 Ω – 2 x 3600 W 230 V @ 16 Ω – 2 x 1300 W
Frequency response
3 Hz – 22 kHz (+/- 3 dB, 8 Ω)
Output Impedance
2 Ω (Minimum load)
Protection
Soft-start, short circuit, overload, low impedance, thermal, DC fault
Damping factor 20 – 500 Hz @ 8 Ω
> 700
Slew rate
62 V/µs
End stages
High Frequency semi soft switched OWM in balanced configuration
Limiter
Programmable limiter (1 V / step), 5 user profile
Limiter setting range
10 – 200 V
Connector
Control input connectors
10 / 100 Mbps Ethernet
Audio signal input connectors
Neutrik XLR
Audio signal output connectors
Neutrik XLR
Speaker connector
4 pole Neutrik, 1+/2+ in parallel, 1-/2- in parallel
AC mains
NEUTRIK POWERCON
AC Mains Power
Operating Voltage
160 – 270 VAC (50 – 60 Hz)
Thermal
Enviromental operating temperature (Cooling)
0 - 40°C
Thermal dissipation
Forced air cooling with regulated DC fans, Front to rear
Test Signal : (1/4 Power) 1 KHz Sinewave 8:32 Burst
~2000 BTU/hour
User Interfaces
Hardware
Ledbar, status LEDs, Graphics LCD, JOGs, buttons, Set by control jog wheels or remote
Dimensions & Weight
Dimensions (W/H/D) mm
483 | 44 | 440 (1RU)
Dimensions (W/H/D) inch
19 | 1 3/4 | 17 3/8 (1RU)
Packing Dimensions (W/H/D) mm
660 | 200 | 630
Packing Dimensions (W/H/D) inch
26 | 7 7/8 | 24 13/16
Weight
21.16 lbs | 9.6 kg
Gross Weight
35.27 lbs | 16 kg
